-23-
Df[\cN(/)0D]^%J`eZ\0&((
FG
<
I
8
K@FEJ
<[^\Af`ek`e^
The purpose of edge jointing is to produce a finished,
flat-edged surface that is suitable for joinery or finishing
(see
Figure
*)
). It is also a necessary step when squaring
rough or warped stock.
Kf\[^\af`ekfek_\af`ek\i#[fk_\j\jk\gj1
(%
Read
and
understand
J8=<KP
, on
GX^\-
.
)%
Inspect your stock for dangerous conditions as
described in the
JkfZb@ejg\Zk`feI\hl`i\d\ekj
instructions, on
GX^\)'
.
*%
Set the cutting depth for your operation.
Efk\1
9\kn\\e
(
Ð
(-
Xe[
(
Ð
/
]fi\[^\af`ek`e^#lj`e^
Xdfi\j_Xccfn[\gk_]fiZ\ikX`ejg\Z`\jfi]fin`[\
jkfZb
.
+%
Make sure the fence is set to 90˚.
,%
If your workpiece is bowed (warped), place it so
the concave side is face down on the surface of the
infeed table.
-%
Start
the
jointer.
.%
Press the workpiece against the table and fence with
firm pressure. Use your trailing hand to guide the
workpiece through the cut, and feed the workpiece
over the cutterhead (see
=`^li\**
).
Efk\
:
@]pflic\X[`e^_Xe[^\kjn`k_`e+f]k_\
Zlkk\i_\X[#c`]k`klgXe[fm\ik_\Zlkk\i_\X[#Xe[
gcXZ\`kfek_\gfik`fef]k_\nfibg`\Z\k_Xk`j
fm\ik_\flk]\\[kXYc\%=fZljpfligi\jjli\fek_\
flk]\\[\e[f]k_\nfibg`\Z\n_`c\]\\[`e^#Xe[
i\g\Xkk_\jXd\XZk`fen`k_pflikiX`c`e^_Xe[`]`k
^\kjn`k_`e+f]k_\Zlkk\i_\X[%B\\gpfli_Xe[j
jX]\Ç;FEFKc\kk_\d^\kZcfj\ik_Xe+]ifdk_\
Zlkk\i_\X[
/%
Repeat
Jk\g.
until the entire edge is flat.
=`^li\**%
Typical edge jointing operation.
=`^li\*)%
Illustration of edge jointing
results.
Portion
Removed with
Jointer
@] pfl Xi\ efk \og\i`\eZ\[ n`k_ X
af`ek\i#j\kk_\[\gk_f]Zlkkf'#Xe[
giXZk`Z\]\\[`e^k_\nfibg`\Z\XZifjj
k_\ kXYc\j Xj [\jZi`Y\[ Y\cfn% K_`j
gifZ\[li\n`ccY\kk\igi\gXi\pfl]fi
k_\XZklXcfg\iXk`fe%
All manuals and user guides at all-guides.com
