Shop fox SHOP FOX W1760, Instructions Manual

Page: 2 / 8

-2-
W1760 20-Gallon Parts Washer
Figure 2. Pump and switch box support
flange.
Switch
Box
Support
Flange
Tub Wall Lip
Choosing Your Cleaning Solution
Not every cleaning solution is safe to use in your parts
washer. NEVER USE GASOLINE, KEROSENE, FUELS,
STRIPPERS, OR ACIDS OF ANY KIND IN THIS PARTS
WASHER. Due to the changing formulas of cleaning solu-
tions, and changing laws and regulations, we cannot rec-
ommend a solution for you. Some solutions can be highly
flammable and may damage pump and motor seals.
If you are in doubt about any aspect of your selected
solution, contact the solution manufacturer, or refer to
the Materials Safety Data Sheet (MSDS) information, which
can be found on the internet. It is your responsibility to
select a safe solution.
To assemble the parts washer, do these steps:
1.
Layout the parts and use
Figure 1
to inventory
them.
2.
Using a #2 screwdriver and a 10mm wrench, secure
the legs to the storage shelf with eight M6-1 x 12
screws, lock washers, and hex nuts.
3.
With the help of an assistant, place the tub onto
the legs and secure it in place with the remaining 16
screws, lock washers, and hex nuts.
4.
Use a 19mm wrench to install the spout and tube
onto the pump outlet (
Figure 1).
5.
Using a #2 screwdriver and a 7mm wrench, loosely
mount the switch box to the side of the pump box
with the two M4-.7 X 10 Phillips head screws, lock
washers, and hex nuts.
6.
Hang the switch box so the tub wall lip slips under
the switch box support flange as shown in
Figure 2
.
7.
Use a #2 screwdriver and a 7mm wrench, tighten the
switch box mounting screws.
8.
Place the work table and parts bin into the tub.
9.
Use a 13mm wrench to make sure the tank drain
plug is tight, and after filling, make sure the plug
does not leak.
Assembly