-14-
Model W1740 (For Machines Mfg. Since 1/13)
SE
TU
P
The handcrank is installed on the front right lift screw
shaft, and is held in place with two set screws already
threaded into the handle.
To mount the handcrank, place the handcrank over the
shaft shown in
Figure.7
and, using a 3mm hex wrench,
secure the handle with the two set screws.
Handcrank.Installation
Figure.7.
Handcrank installation.
DO. NOT. operate. this. machine. without. an. adequate.
dust.collection.system..This.machine.creates.substan-
tial.amounts.of.wood.dust.while.operating..Failure.to.
use.a.dust.collection.system.can.result.in.short.and.
long-term.respiratory.illness.
Recommended.CFM.at.Dust.Port:................. 150.CFM
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the
dust port, you must take into account many variables,
including the CFM rating of the dust collector, the length
of hose between the dust collector and the machine, the
amount of branches or Y's, and the amount of other open
lines throughout the system. Explaining this calculation
is beyond the scope of this manual. If you are unsure of
your system, consult an expert or purchase a good dust
collection "how-to" book.
Dust.Collection
To.install.the.dust.port,.do.these.steps:
1.
Remove the four Phillips head screws at the dust
port hole.
2.
Place the 2
1
⁄
2
" dust port over the top cover mount-
ing holes and secure with the Phillips head screws
removed in
Step.1,.
as shown in
Figure.8
.
3.
Attach a 2
1
⁄
2
" dust hose to the dust port and secure
with a hose clamp.
Note
:
A tight fit is necessary for
proper performance. Also, a fine layer of dust will
always be present on workpieces as they come out of
the sander—this is normal.
Figure.8.
Dust port installation.
