-24-
Model W1701 (Mfd. Since 12/21)
O
PE
R
ATI
O
NS
Spindle Elevation
Correct spindle height is crucial to most shaping
applications. Use a piece of test wood to confirm the
correct spindle height before cutting expensive lumber.
To set spindle height, do these steps:
1.
Loosen spindle lock knob located on side of shaper,
as shown in
Figure 18
.
2.
Move spindle height lever, shown in
Figure 19
, right
to raise spindle, or left to lower spindle.
3.
Retighten spindle lock knob on side of shaper. DO
NOT over-tighten the knob. Only small amount of
tension is needed to keep spindle from moving
during operation.
Spindle Direction
The Model W1701 is capable of operating in two
directions by use of the forward and reverse switch
shown in
Figure 20
.
It is very important that the workpiece be fed against
the direction of the cutter rotation. This will prevent a
climb cut and maintains a safe cutting procedure for the
operator.
Most operations are done with the switch in the FWD
position. However, there will be times when it is
necessary to flip the shaper cutter over and run the
spindle in the opposite direction (REV).
• When the switch is pointing to the FWD position, the
spindle and cutter rotate counterclockwise.
• When pointing to the REV position, the spindle and
cutter rotate clockwise.
CUTTER CONTACT HAZARD!
Feeding the workpiece in the same
direction that the cutter is rotating
may result in a climb cut, which
can pull your hand into the cutter.
Always feed the workpiece AGAINST
the direction that the cutter is
rotating to reduce this risk.
Figure 20.
Forward and reverse switch.
Figure 19.
Spindle-height lever.
Figure 18.
Spindle lock knob.
