-19-
M1039 12-Speed Drill Press
SE
T
U
P
Test.Run
Serious. injury. or. death. can. result.
from. using. this. machine. BEFORE.
understanding. its. controls. and. related.
safety.information..DO.NOT.operate,.or.
allow.others.to.operate,.machine.until.
the.information.is.understood..
DO. NOT. start. machine. until. all.
preceding.setup.instructions.have.been.
performed..Operating.an.improperly.set.
up. machine. may. result. in. malfunction.
or. unexpected. results. that. can. lead.
to. serious. injury,. death,. or. machine/
property.damage.
Figure.23.
Removing switch key from
paddle switch.
Once assembly is complete, test run the machine to
ensure it is properly connected to power and safety
components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from power,
and fix the problem BEFORE operating the machine again.
The
Troubleshooting
table in the
SERVICE
section of this
manual can help.
To.test.run.the.machine,.do.these.steps:
1.
Clear all setup tools away from machine.
2.
Connect machine to power supply.
3.
Turn machine
ON
, verify motor operation, then turn
machine
OFF
.
The motor should run smoothly and without unusual
noises.
4.
Remove switch disabling key (see
Figure.23
).
5.
Try to start machine with paddle switch. The
machine should not start.
— If machine
does not
start, the switch disabling
feature is working as designed.
— If machine
does
start, immediately stop the
machine. The switch disabling feature is not
working correctly. This safety feature must
work properly before proceeding with regular
operations. Call Tech Support for help.
For your convenience, the adjustments listed below have
been performed at the factory and no further setup is
required to operate your machine.
However, because of the many variables involved with
shipping, some of these adjustments may need to be
repeated to ensure optimum results. Keep this in mind as
you start to use your new drill press.
Recommended.
Adjustments
Step-by-step instructions for these
adjustments can be found in the
.SERVICE.
section of this manual.
1.. Depth.Stop.Calibration.(Page.28)
2.. Feed.Shaft.Spring.Tension.(Page.29)
