START-UP
WARNING:
Eye protection should always be worn by the operator and others in
the work area when setting up the machine. Eye protection is
required for protection from flying debris and dust, which could cause
eye injury.
Before shipment, your Supreme Finisher was checked at the factory for proper adjustment
and operation. However, due to the possibility of jarring or damage during handling and
shipping, it is necessary to check that the machine is in proper working order before use.
WARNING:
Before initial start up, turn sanding belt by hand to ensure that all
parts are free. Do not start Finisher before checking for proper
sanding belt tracking.
BEFORE CONNECTION TO AN ELECTRICAL POWER SUPPLY:
1.
Check that all switches are off.
2.
Rotate the wide sanding belt to see that all parts are free and not binding. Continue
for one complete rotation of the sanding belt, checking wide belt for tears or other
damage. You can tell that one complete revolution has been made when the joint of
the sanding belt has gone by the front pulley twice.
3.
Rotate the trimmer section by moving the sole trimmer guard and turning the
feather edge back guard by hand. Observe the cutter sharpener grinding stone for
any damage.
4.
Rotate the Naumkeg by hand to see that the sanding pad is not damaged and the
shaft not bent.
WARNING:
As with any piece of electrical equipment, there is an ever present
hazard of electrical shock when operating or touching the Finisher.
Ensure the machine is properly grounded at all times.
Do not force the equipment. It will do the job better and safer at the
rate for which it was designed.
5
