MOTOR REPLACEMENT
WARNING:
Motor replacement requires working with electrical wiring and can be
hazardous. If you are not familiar with electrical procedures, please
call a qualified electrician.
DUST EXTRACTOR MOTOR
The dust extractor motor can be easily removed from the front of the machine.
To remove the motor, these directions should be followed.
1.
Disconnect the electrical power supply.
2.
Remove motor electrical box plate and observe the electrical wires connected.
3.
Mark the electrical wires to the motor such that you will be ABSOLUTELY
CERTAIN where to reconnect them to the new motor.
4.
Disconnect the electrical wires and the connector on the motor box.
5.
Remove the eight (8) nuts and washers holding the motor plate to the machine.
6.
Remove entire assembly of motor plate, motor and blower wheel from the machine.
7.
Loosen the two (2) screws on the fan.
8.
Pull the blower wheel off of the shaft.
9.
Remove the four (4) screws that hold the motor to the motor plate.
10.
Reassemble with new motor in reverse order of above.
11.
Reconnect the power supply.
12.
Turn the blower motor on and place your hand near a dust extraction port to see
whether the blower is not running backwards.
If you do not already know how to fix this without referring to this manual, call a
qualified electrician.
WARNING:
Be absolutely certain to reconnect the electrical wire to the proper
terminals.
Failure to do so can result in improper motor rotation, a ruined
motor, fire, or injury to yourself.
16
