6
STEPS TO SET UP THE SUSPENSION MODULE
1
Turn the 3-position lever at the base of the shock
absorber to the SOFT position. See page 5.
2
Pressurize the shock absorber to 100 PSI and remove
the pump.
3
Cycle the shock absorber through its travel by
bouncing on the seat 5 times. This will equalize the
positive and negative air chambers.
4
Use the pump to pressurize the shock absorber
(in PSI) to match the weight in pounds (lbs), of the
occupant and seat. Remove the pump before step 5.
5
Cycle the shock absorber through its travel by
bouncing on the seat 5 times.
6
Push the red o-ring against the rubber air sleeve.
7
Gently sit on the seat.
8
Get out of the seat.
9
Check the sag percentage marking on the Shock
absorber shaft. Sag is correct if the o-ring sits at
the 20% mark.
10
If the sag value is not at the desired level, inflate
or deflate the shock absorber in 10 PSI increments
and repeat steps 5-8 until the desired sag level
is achieved.
Do not sit on the seat with the SHOCKWAVE S5 Pump attached!
Damage will occur to the shock and pump. Note, SHOCKWAVE
S5 PUMP sold separately.
Do not exceed 350 PSI. The maximum shock absorber pressure.
