SHM GRVFE24LMV, Owner'S Operation And Installation Manual

Page: 11 / 24

LOG SET PLACEMENT IN FIREPLACE
XXXX
XXXX
XXXX
XX
Glowing Embers to the
area marked with
“XXX” (see Figure 6
).
Do not apply
Glowing Embers
to the main burner.
Figure 6- Glowing Ember Placement
INSTALLATION
(Continued)
DECORATIVE CRUSHED SHALE
Included with this Gas Log Set is a bag of Crushed
This Shale is provided to enhance the look and feel
of your log set and fireplace. Its only function is to
be decorative. Simply spread the Crushed Shale on
your fireplace floor around the bottom of your log
set burner/grate to give the appearance of burnt
ash. It can also be used to cover your gas supply
Caution: Never place the shale, or any other object
(not provided with your gas log set and instructed
for that purpose) onto the burners of the unit.
Be creative in the placement. You do not have to
use all of the supplied shale.
CRUSHED SHALE SHOWN
AS PROVIDED
line coming from the wall to your burner.
Shale ( see Figure 7 ) .
Figure 7- Crushed Shale
11
OPTIONAL ON/OFF
REMOTE CONTROL SET
INSTALLATION AND OPERATION
- + - +
COMMUNICATION BETWEEN THE
REMOTE CONTROL TRANSMITTER
AND THE RECEIVER
To program the transmitter to the receiver , move
the three positions slider of the receiver inthe
REMOTE
position and depress the
ON/OFF
key
of the transmitter. The System has an automatic
learning mode that allows the receiver to mate
with a new trans - mitter in the event the trans
mitter must be replaced. Assoon as the receiver
module receives the firstcorrectcommand from
any remote control it captures the new address
and then "beeps"3 times to confirm the syncron-
ization and command execution..
Remote control set NOT included with log set. If
using the optional remote control set, follow these
additional instructions.
Install four
( 4) "AA"
batteries into the
remote receiver box
as shown on the left.
Install three
( 3) "AAA"
batteries into the
remotecontrol
as shown on the left.
Be sure to place the remotereceiver in a cool loc-
ation in the fireplace. Do not place the reciever
in a location directly in front of the burner system.