8
■
Connecting the Power Supply
1
Make sure that the operating switch is “OFF”,
then plug the power plug into AC power outlet.
3-2. Operating Procedures
■
Ignition Procedures
• When smell, smoke, wrong burning, etc. takes place, stop immediately operation to
avoid a fire,and contact your dealer.
• If the heater does not ignite with three consecutive tries, stop trying more than three (3)
times, to avoid a fire, and contact your dealer.
• When using the heater, be careful so that the floor surface (in front of it ) may not get
overheated.
• Do not operate the heater, while fuel tank is dirty and foul, to prevent poor ignition or
wrong burning.
CAUTION
1
Use the fuel gauge to check if the fuel is
sufficiently filled up in the tank.
2
Set “ON” the operating switch, and the
heater will ignite in about 5 seconds.
Operating Switch “ON”
Observations
• Not to miss the ignition, please do not leave the heater until you confirm that it is properly burning.
AC Outlet
Power Plug
Connect
■
Shut-Down Operation
CAUTION
• After the operation is shut down, please make sure that the flame is completely extin-
guished before leaving the place.
Turn “OFF” the operating switch, and the
heater flame will be extinguished, then the
fan motor will also automatically stop after
about five (5) minutes.
If ignition fails, try again its proce-
dures as follows
●
If the heater is used for only a short period of time after refu-
eling, air inside of the fuel pipe may cause the flame to flicker
when the heater is shutting down. This is not abnormal.
First, switch the operating switch “OFF”,
and try the ignition sequence again.
Operating Switch “OFF”
Operating Switch “OFF”
Observations
• To disconnect the power plug from the AC outlet, please make sure that the fan motor is stopped.
• Never disconnect the power plug while the heater is operating, it will cause nozzle to be clogged.
2
Make sure a grounded power pin or connec-
tion is used.
Val6_Daystar_PH1_OM_Multi.indd 8
14/03/27 15:35
Summary of Contents for val6 daystar
Page 16: ......
