Shivvers Circu-Lators I, Installation Manual

Page: 43 / 43

Circu-lator Installation Final Check
42
Check that all joints are level and solid, without cracks, in the tapered sweep
wheel track, and that the track is pop riveted, not screwed, down.
Make certain the tapered sweep wheel(s) do not hit pop rivets in the track.
Make sure the tapered sweep augers have "flex" in the coupling by lifting the
outer end in several locations around the bin.
Make sure gearbox is square with the floor. Use gearbox laser kit.
Check that the chain coupler master link is installed correctly.
Make sure there is 1/8 - 1/4" gap between the horizontal flight weldment tube
and the sprocket on 1" drive shaft where O-ring is located, inside the basket.
Make sure the Center Vertical is plumb.
Make sure the spreader wheel has fins installed as needed and extra fins are
given to the operator.
Make sure center vertical chain turnbuckles are wired to prevent loosening.
Check pickup fingers for proper clearance and engagement. Make sure the
cone is all the way into the spider wheel.
Make sure the 3-jaw clutch and unloading pin will operate correctly.
Check belt alignment and tension. Make sure belts don't try to roll over.
Check slide gates for proper operation and leave them in the closed position.
Make sure all Safety Decals are in place as shown in P-10001 Operator's
Safety Manual. Make sure all guards are in place.
Make sure the Safety Lock Kits (632-101A) are installed as shown in this
manual and P-10001 Operator's Safety Manual, and P-11175 Instructions.
Either the bin entrances or the power should be locked off.
Make sure the operator has the Operator's Safety Manual, Operating manuals
for each piece of equipment installed, and Safety Lock keys. Make sure they
understand how to operate each piece of equipment safely.
1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16
