1
Check and ensure that no raised grain or
splinters are evident on timber components.
Sand down any raised grain or splinters
using fine grade sandpaper.
2
Check that all screw, nail and pin heads are
properly tapped home and are not proud of
the timber surface.
3
Check and ensure that no screws, nails or
pins protrude through any panel.
4
Check and ensure that all parts are properly
secured against reasonable force.
5
Do not apply decorative wood
finish/treatments to wet or damp timber.
Please observe the instructions of the wood
finish/treatment manufacturer.
Assembly Completion Checklist
3 Place the smallest piece of felt at
the peak (ridge) of the building. This
piece will overlap both of the other
pieces of felt. Nail into position
along both edges of this piece and
at both ends.
2 Starting at the lower edge (the
eaves) place one 1 mtr wide piece
from the front to the back of the
building. An overhang of
approximately 45mm should be
allowed on each of the 3 sides
although the felt will overhang at the
back by more than this. Secure the
felt using felt nails spaced at
100mm intervals. Repeat, but do not
nail along the centre of the building
until the piece of felt covering the
ridge is in place.
1 Screw all side panels to the floor on
the inside of the building using 1x
60mm screw per separate panel
and 1x 80mm screws into each of
the two panels ‘B1’ either side of the
doors.
I
-
Secure Walls to Floor
K
-
Facias & Diamond Assembly
1 Fit four facia boards ‘K’ to either
sides of the roof using 3x 40mm
nails per piece.
J
-
Fit Coverstrips
1 Cover strips ‘I’ are nailed over the
joins between all side panels and at
each corner. Secure in place using
4x 40mm nails per strip.
2 Carefully trim off excess felt with
cutting knife against the edge of the
facia board.
3 Nail diamonds ‘K1’ on top of and in
the centre of the facia board using
2x 40mm nails per diamond.
L
-
Placing Glazing Material in Window
1 Place glazing material ‘L’ into the
aperture of each window.
2 Hold into position with four pieces of
beading ‘L1’. The beading may
need to be swapped around to get
the best fit. When satisfied secure
into position using 2x 15mm panel
pins per piece of beading. Repeat
for all window apertures.
H
-
Felt Roof
1 Two rolls of felt ‘J’ have been
supplied. Lay out the largest roll
and cut in half length ways..
9 Place outside door cover strip 'D1'
flush with the top and bottom of the
door and mark top and bottom of
padbolt position.
10 Attach the door stop strips above
and below the padbolt. Half of
each strip should overhang the
edge of door 'D' and when closed
also overhang the left hand door
'E'. Secure using 5x 25 mm
screws.
Cut out
section as
marked
8 Place padbolt housing in position to
accommodate the padbolt. Secure
using 2x 25 mm screws using the
round holes only.
