GB-IE
18
Soffit Panel
(A2430) x01
Small Roof
(A2432)x 01
Place the
A2423 Small roof
in position so the framework drops over and into the w shape in the top of
the gables and push it tight to the blocks and measure and position with an even overhang each end.
Mark and drill 3 holes up each slope
67mm
(make sure the upper one goes into the location block) in
from the roof edge and screw into the frame below and not too low as to be outside the bottom edge.
The lower holes just nip the screws up so not to crack the cladding.
Mark a line
95mm
up from the bottom edge and drill 4 holes and again just nip he screws up.
11
GB-IE
Drill 6 holes in the
A2430 soffit panel
Align the framework on top of and with the inside of the front panel frame and with the gables framework.
Fix to the gables first and then to the front panel with the holes drilled earlier.
10
60mmScrew
(A0035)x09
60mmScrew
(A0035)x10
5 mm
You must have at least
two helpers to hold this
panel in place
5 mm
