Shindaiwa DG60MI, Owner'S And Operator'S Manual

Page: 14 / 52

11
Stop Mode Button
Manual Mode Button
Auto Mode Button
Lamp Test /
Air Bleeding Button
Start Button
5-1. Controller
This generator has a Controller which is used for starting or stopping the power generator
or the engine, for monitoring. If you turn the Power Switch to ON position, the status
Screen appears.(Refer to section "
5-1. Controller (2)Operation Display ".)
(1) Button
○
Stop Mode Button
This button places the controller into its Stop Mode.
Pressing this button stops the engine and deletes any resolved alarms.
○
Manual Mode Button
This button places the controller into its Manual Mode. (Refer to section
"
9-1. Initial Startup/Pre-Check (1) Manual Start ")
○
Auto Mode Button
This button places the controller into its Auto Mode. (Refer to section " 9-1.
Initial Startup/Pre-Check (2) Auto Start ")
○
Lamp Test / Air Bleeding Button
While this button is pressed, all LEDs on the controller are turned on as a
lamp test function. Press and hold for approximately 2 seconds to
automatically starts air-bleeding device. (Refer to section "
9-2.Procedures
during Operation (2)Adjustment during Operation ")
○
Start Button
Pressing this button in Manual Mode starts the engine. (Refer to section
"
9-1. Initial Startup/Pre-Check (1) Manual Start ")
5. Equipment