Shindaiwa DG50MK-P, Owner'S And Operator'S Manual

Page: 35 / 48

32
< Note >
Refer to section “ 8-2. Checking Coolant ” for coolant
information.
Replace the packing of the coolant drain plug with new packing
each time the coolant is changed.
Packing part no.: 6C090-58961 (Kubota part no.)
After reinserting the coolant drain plug and shortly after starting the engine, be sure to always
check that there is no coolant leakage.
(8) Flushing Liquid in Spill Containment
Check Daily
Set a container to collect liquid from the flushing port of the
drain valve on the front of this generator.
Remove the drain valve plug (R 1/2”) and open the valve
lever.
< Note >
When removing or attaching the plug, hold the drain valve fixed using
a spanner or similar tool and turn the plug.
If oil or other liquid is mixed in with the flushed liquid, this indicates that
there is an oil leak. In such case, check for the leak location.
The types of liquids that can accumulate in the spill containment
include oil, fuel, coolant water and battery fluid such that it is not
possible to distinguish between rain water and other liquids. Dispose of
flushed liquids according to the related laws and regulations.
Close the valve lever after the liquid has been flushed, and
apply sealant coating to the plug or wrap it in seal tape.
(9) Spill Containment Cleaning/Inspection
WARNING : INJURY
Do not lift up the unit using tie downs. Use of such could result in the generator falling.
No persons should be under a lifted generator.
CAUTION : INJURY
Always be sure to use lifting hooks when lifting up the generator, and raise it
slowly at a completely vertical angle.
Personnel performing lifting work must wear protective gear such as helmets,
safety shoes and gloves.
Do not move the generator during operation.
Clean Every 500 hours
Separate the spill containment from this generator to clean and inspect the spill containment.
3
1
2
Plug(R1/2”)
Drain Faucet Lever
Drain
Drain Faucet
Lever
Clos
Open
Plug
Loose
Tighte
Fixin
Drain