Shindaiwa AH243S, Operator'S Manual

Page: 18 / 156

16
Before you start
2. Loop the ribbed cable tube under the tube and to the top left
side of the engine and push cable through the cable adjust-
er.
3. Connect the bullet shaped end of the throttle cable to the
throttle lever on top of the carburettor.
4. Connect ignition leads.
Adjusting Cutting Angle
Adjusting the hedge trimmer cutter assembly
1. Position the hedge trimmer on a flat, level surface with the
engine resting on the fuel tank guard. Make sure the scab-
bard is in place on the blade.
1. Throttle cable
2. Cable adjuster
3. Ignition leads
NOTE
Make sure the ribbed cable tube is on the left side of the engine
before connecting the throttle cable.
1. Throttle cable
2. Connect end of Throttle cable here
1. Ignition leads
CAUTION
 
Wiring runs must not interfere with throttle operation.
1. Adjustment lever
WARNING

Wear heavy duty gloves when working with the hedge
trimmer blades. When replacing the hedge trimmer
blades during a trimming task, ensure that the engine is
switched off and that the blades have stopped.
‹
Failure to do so could lead to an injury or serious accident,
or cause a fire.