Shindaiwa AH243S-LW, Operator'S Manual

Page: 17 / 164

15
Before you start
Before you start
Assembly
Connect the outer tube to the powerhead
1. Place the powerhead on a clean, flat surface, spark plug fac-
ing up.
2. Slip off the protective cover from the end of the outer tube.
3. Use the 4 mm hex wrench to loosen the tube clamp screw.
4. Slide the outer tube into the tube clamp until the tube bot-
toms. If installation is difficult, rotate the outer tube or main
shaft slightly until you feel the mainshaft splines engage with
the powerhead.
5. Position the outer tube so that the gearcase output shaft is
facing left on silencer cover.
6. Slide the outer tube into the powerhead until the throttle grip
just contacts the tube clamp.
7. Tighten the clamp screw firmly.
Connect the throttle cable
1. Loosen the air cleaner cover knob and remove the air clean-
er cover.
WARNING
Read the operator's manual carefully to ensure that you assemble the product correctly.
‹
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
1. Spark plug
2. Tube clamp
3. Clamp screw
4. Mainshaft
5. Grip
6. Trigger housing
7. Outer tube
8. Protective cover
WARNING
 
Ensure that the fuel tank cap is securely in place.
‹
Failure to do so could lead to an injury or serious accident,
or cause a fire.
1. Hex wrench
2. Tube clamp
CAUTION
 
Do not force the shaft tube into the powerhead.
‹
Excessive force can damage the shaft tube and mainshaft.
1. Air cleaner cover