7
Install Gear Case
1. Install gear case onto outer tube. Align locating hole
on gear case with locating hole in tube.
2. Install locating bolt (A) and tighten clamp bolt (B).
A
B
Install New Cutting Attachment Shield
G
A
C
C
D
A
B
E
Assemble the Cutting Attachment Shield to the Outer Tube.
1. Insert the cutting attachment shield (A)
between the outer tube and the cutting
attachment mounting plate (B).
2. Fit the two shims (C) and the upper
clamp (D) over the outer tube and install
the four socket-head cap screws (E)
finger tight.
CAUTION!
Make sure the clamp screw and retain-
ing nut (F) are securely tightened before
tightening the four socket head screws
.
3. Tighten the four socket-head cap screws
to secure the cutting attachment shield.
F
Sub-Shield.
(when trimmer head is in use)
1. Attach the sub-shield (G) extension to
the cutting attachment shield (A).
WARNING!
NEVER
use this machine without sub-shield when us-
ing a trimmer head.
CAUTION!
Make sure the sub-shield is completely hooked at the
hook receiver.
WARNING!
NEVER operate the unit without the cutting attachment
shield installed and tightly secured!
WARNING!
A cutting attachment shield or other protective device is
no guarantee of protection against ricochet. YOU MUST
ALWAYS GUARD AGAINST FLYING DEBRIS!
