Removing Collected Water
There are
three
ways to remove collected water:
1. Use the bucket
When the bucket is full, remove the bucket and empty it.
Do not move the unit at this time otherwise water may spill on the floor.
Press sides of bucket gently to unclip the bucket from the unit.
Remove the bucket as shown in the photographs below and empty the
bucket.
Discard water from bucket. Water is not potable and cannot be used for
drinking
2.Pump drainage.
Unscrew the water cap counterclockwise, and then pull out the black
rubber water plug.
•
First, to use the pump function, you need to connect a tube with an
inner diameter of 5mm. We have two tubes delivered together with
the machine. The thinner one is a 5mm tube, but the length is only 2
meters.
•
Then,after you connect the tube, you need to press the Humidity
Setting button(which is under the pump indicator light) for three
seconds to start the pump function.
•
And the pump indicator light will turn in red.This means that the
function of your pump is turned on.
9
