Assembling the bracket
and lever
1.
Put the cable hook in to the bearing member, and
set the return spring.
2.
Set the special installation tool for the return spring.
Bearing
member
Cable hook
Return spring
Set the end of the spring in
the hole in the bearing
member. Note that the
spring has a right and left
side.
Return spring installation tool
(TL-ST02)
Hole
3.
First insert the sensor cable into the bracket body,
and then assemble the bracket body and lever body.
Be careful that the end of the return spring does not
protrude from the hole in the bearing member at
this time.
Lever
Bracket
Make sure the spring is properly positioned.
Do not disassemble any futher as reassembly may
not be possible.
3.
Disassemble as shown.
• Be sure to regrease.
Grease
