Installation to the handlebar
Secure the assembly with the installation nut on the outside
of the bracket. Pull the bracket cover back and use a 5 mm
Allen
key to tighten the bolt.
Tightening torque:
6 - 8 N·m {50 - 70 in. lbs.}
Installation
Bracket cover
5 mm Allen key
Installation nut
3.
Fix the outer guide to the inner cable, and set the angled
member in the bracket.
Note:
Do not wipe the grease on the inner cable off.
Also, be careful that the inner cable does not pick
up dust and foreign matter.
Bracket
Angled member of
outer guide
Inner cable
Outer guide
(Parts sold separately)
4.
Set the outer casing on the inner cable, and in the
bracket along the outer guide.
Outer holder
Cable guide
Make sure that the inner
end is firmly seated in the
cable hook.
Cable hook
Inner end
Outer casing
5.
Bring the outer casing along the front of the handlbar
and cover it with the outer guide. Now cut the outer guide
to the length of the handlebar, and tape it temporarily in
place.
6.
Finally, wrap the handlebar with the finish tape.
Tape
Outer casing
Outer guide
Note:
The front lever cannot be tilted to
the inside until lever b
F
is pushed
once or twice.
Installation of the brake cable
Be sure to leave some excess cable, even if cutting it to the
full length of the handlebars.
1.
Tilt the lever in (as when shifting) to make it easier to
pass the cable through the cable hook.
Lever
b
F
2.
Pass the inner cable through.
Inner cable
Cable hook
Pull
Tilt
Cable used
• Inner cable (stainless steel)
• • • • • • •
• SLR outer casing
• • • • • • • • • • • • • • • • • • •
f
1.6 mm
f
5 mm
