Shimadzu UW2200HV, Instruction Manual

Page: 67 / 130

51
11. Environment
Read Chapter 7 Before Use of
These Pages
It is possible to adjust the operation with the following stability detection settings.
(a) Stability Detection Band (
11.3.1 )
(b) Timing of Stability Mark Illumination and Automatic Output ( 11.3.2 )
It is not usually required to change these settings as they are optimized at default. However, it is
allowed to change according to
11.3.1 and 11.3.2 when: wishing to ease the criteria of stability detec-
tion under very unstable environmental or sample conditions, or wishing to accelerate automatic data
output when using a function that employs stability detection.
11.3.1 Stability Detection Band
The default setting is “1 count” and the measurement is regarded to be stable when the display has
remained within one display count for a fixed length of time. If stability detection band is set at
“2 counts”, it will be regarded to be stable when the display has remained within two display counts.
Selecting a larger stability detection band generally eases the criteria and makes stability mark illumi-
nate more readily. However, it will be more likely for the display to further fluctuate after illumination of
stability mark.
Try a larger stability detection band when data outputs triggered by stability detection is slow due to
very unstable environmental and/or sample conditions.
*Not applicable to a verified balance as a legal measuring instrument in the EU.
Note
Stability mark is an auxiliary device to inform measurement stability. The
displayed value may change while the stability symbol remains illuminated
if the load is changing slowly, or depending on the stability detection set-
tings.
Stability
detection band
1 count
(default setting)
2 counts 4 counts 8 counts 16 counts* 32 counts* 64 counts*
Menu item
number
Note
Use “16 counts” to “64 counts” for Auto Print, Animal Weighing or other
data-outputting function under very unstable conditions only.
27 28 29 30 31 32 33