Saving Parameters and Configs
Any changes you’ve made to the config file will be accessible to the device after saving. If you want to hear the
changes on the fly, remember to rescan the config file by changing the MODE switch position. The settings saved in
the config file will remain in the pedal until the file is deleted. If needed, make a backup for the file on a different
drive. Ready-made patch sets can be uploaded to the pedal by replacing the config file. The file name (PRISM2.SET)
should not be changed.
Reverting to Default Settings
If you’ve edited the config file and wish to revert to default settings, you can easily restore the default config file.
Simply delete the unwanted config file from the AFXSETUP folder, and the pedal will go back to factory settings.
MIDI Config
The stability of MIDI Clock messages depends on the source, which may or may not be perfect (particularly when
Clock and CC messages are transmitted simultaneously). For best performance, the interval between two
consecutive messages should be set accordingly. We recommend setting the CC message interval to 17-20ms.
The Prism II is connected to the MIDI source via a MIDI Type A 6.3mm TRS jack. The wiring scheme is as follows:
MIDI 4 (Source) > TRS RING,
MIDI 2 (Shield) > TRS SLEEVE,
MIDI 5 (Sink) > TRS TIP.
Read more about MIDI standards here.
You can also use a TS connection (a 6.3mm mono jack into a DIN-5 input). To make such a converter, only use the
following connections:
MIDI 2 (Shield) > TRS SLEEVE,
MIDI 5 (Sink) > TRS TIP.
MIDI Implementation Chart
