-18-
Trouble Shooting
Under the proper circumstances, your Vacuum Sealer will give you many top-notch
vacuum performances. In some instances, problems may arise. Please consult the
trouble shooting menu before calling customer support.
Note:
* Suggest stopping for about 20 seconds between each working cycle.
* When machine is under long time working and is overheat, the thermal
overload will start to protect the machine. “E” appears on the digital display.
In this case please shut down the machine and cut off the electricity, and
allow the machine rest for about 20mins. And then re-connect and re-start
the machine.
* There will be error “E” shown on the digital display when the vacuum
chamber is taken out or not well locked but any of the “Start” “Seal” or
“Pause” button is pressed. Please put back the vacuum chamber and well
lock it, the machine will start working again.
* When LED display shows "E1" signal, please contact specialized persons to
repair it.
The Vacuum Sealer won’t turn on
▪
Ensure that the machine is properly plugged into a grounded outlet.
▪
Check the power cord for tears and frays. Do not use machine if power cord
is
damaged.
▪
Check if the vacuum chamber is well locked.
Summary of Contents for Shield Sealer SNS70
Page 1: ...User Manual Shield Sealer Model SNS700 ...
Page 22: ......