EN - INSTRUCTION MANUAL
Model: 12-24V 25A, for batteries: 5Ah - 800Ah
The new series of electronic battery chargers has been designed to charge all kinds of lead-acid, traditional or latest
generation batteries and LiFePO4 lithium batteries. These chargers are particularly suitable for daily use and for
long-lasting maintenance charges.
All charging parameters are set using the charging function keys on the control panel. Depending on the model, you
can set:
-
battery type (std: wet or gel, AGM: efb, start & stop or spiral, lithium: LiFePO4)
-
charging current according to battery capacity
-
the charging voltage according to the battery voltage
-
the duty cycle to be carried out: slow, medium and fast charge; deep recovery charge, show room
function and power supply as a replacement to the battery.
Battery state diagnosis stage A1
The charger state of charge of the battery to be charged.
Charging phase:
"Recovery from deep discharge”
The charger starts using a pulse current until the battery has reached
optimal voltage and current levels to start the second charging phase.
Charging phase:
" soft I”
Reduced constant current charge
Charging phase :
" I”
Charge at constant current until the maximum battery voltage is reached.
Charging phase :
" U0”
Charge at stabilized voltage until the current reaches minimum values.
Charging phase :
" Recovery” *
Only with charger set on RECON: constant current deep charge phase and
increasing voltage to increase battery charging capacity.
Diagnosis of battery status: "A
2”
The charger analyzes the state of efficiency of the charged battery.
Charging phase:
" U”
The battery charge status is maintained at a reduced constant voltage.
Charging phase:
" Up”
The battery charge is maintained with pulses of current (provided
constantly).
•
*
RECOVERY function (RECON): this charging mode allows you to recover wet 12volt batteries that have been
inactive for a long time and have acid stratification. This function acts physically on the electrolytic solution of
the battery so that it mixes again counteracting the stratification.
•
SHOW ROOM function: the chargers are equipped with the show room function. This function allows for
operation of all the vehicle utilities during demonstrations in the dealership. (Only in 12V mode)
•
SUPPLY function: the chargers are equipped with the supply function (power supply). This function allows you
to keep the memory of a vehicle active during battery changes or in all cases where the battery is disconnected
from the vehicle circuit. (Only in 12V mode)
•
For battery analysis and error reporting the chargers have been designed to analyze the battery status before
and during charging and report any anomalies in connection between the charger and the battery to be
charged. Through the digital display an error code is displayed, so as to quickly and easily verify the anomaly
that has occurred.
WARNING
•
The charger is intended for charging lead acid and lithium (LiFePO4) batteries. Do not
use for other purposes. Do not charge non-rechargeable batteries. Do not charge
frozen batteries.
•
This appliance should not be used by persons (including children - under 8 years of
age) with reduced physical, sensory or mental capabilities, or without sufficient
knowledge and experience, unless they are supervised and have received adequate
instructions.
•
Keep away from children. This appliance should not be used as a toy.
•
Always wear protective goggles and protect your face from the battery during
connection and disconnection.
•
Explosive gases may be emitted when charging the battery, so avoid sparks or flames
and do not smoke.
