CONTROLS, INSTRUMENTS AND OPERATIONS
13
KEY SWITCH
The key switch is shown in Figure
9.
Turning the key to the right to the “ON” position will
activate the indicator lights and instruments.
Turning the key further right to the “HEAT” position
will active the cold-start aid.
Turning the key to the fully clockwise to the
“START” position will start the engine. Upon re-
lease, the key will spring return to the “ON” posi-
tion.
To stop the engine, turn the key to the “OFF” posi-
tion.
Figure 9 - Key Switch
IMPORTANT
:
:
:
:
The key switch must remain in the
ON position while operating the engine. The warn-
ing lights and battery charging system will not func-
tion with the switch in the OFF position.
PRE-HEATING THE ENGINE
Your tractor has a diesel engine. Before starting a
cold engine, the pre-combustion chambers must be
heated.
To preheat the engine, turn the key switch to the
“HEAT” position, Figure
9
and hold the key in this
position for approximately 5 seconds. The glow
plugs heat the combustion chambers during this
time, and the engine will now be ready to start.
NOTE:
When ambient temperature are colder, a
longer preheat time may be necessary. Even after
the cold start indicator light has gone out, the glow
plugs will continue to heat if the key is held in the
“HEAT position.
WARNING
:
:
:
:
Do not use ether with the
thermostat starting aid.
STARTING THE ENGINE
The safety key switch allows activation of the start-
ing motor only when:
1. The rear PTO is in the “OFF” position.
2. The mid PTO is in the “OFF” position, if
equipped.
3. The range lever is in the “NEUTRAL” position.
Figure 10 - Rear PTO, Mid PTO and Range lever
Always use safety practices when starting your
tractor.Position the hand throttle rearward so that it
is one-fourth to one-third open when starting the
tractor. After starting return the throttle to the idle
position and allow the engine to idle for 1 minute
before operating the tractor.
IMPORTANT
:
:
:
:
Do not engage the starting motor
continuously for more than 30 seconds ; doing so
may cause starting motor failure.
NOTE
:
:
:
:
A coolant immersion heater which provides
for easier starting in temperatures below 0
°
F
(
-
17.7
℃
) by warming the engine oil and coolant,
Summary of Contents for ST329
