ENGLISH
17
Programming a macro function
• The macro function enables you to program a
series of button operations(up to 10) on this
remote control into a single button.
• You can store up to three separate macro
command sequences into “M1”, “M2” and “M3”
buttons.
• If the macro mode is entered, the LED will flicker
once.
Example: When programming a series of button
operations into “M1” button.
1.
Press and hold down both “ENTER” button and
one of three NUMERIC buttons (“1” ~ “3”)
corresponding to “M1”~”M3” buttons for more
than 1 second.
■
Note :
You should press the corresponding DEVICE
buttons before pressing each operation button.
Example: When playing a BD on the BD player
connected to VIDEO 2 jacks of this
receiver.
①
. Press “AVR” button to control this receiver.
②
. Press “POWER ON” button to turn this
receiver on.
③
. Press “AVR” button to control this receiver.
④
. Press “VIDEO 2(7)” button to select the
desired input source.
⑤
. Press “BD” button to control the BD player.
⑥
. Press “POWER ON” button to turn the BD
player on.
⑦
. Press “BD” button to control the BD player.
⑧
. Press “
▶
” button to start playback.
2.
Press the operation buttons you want to
program in order.
3.
Press “ENTER” button.
• If the programming is performed successfully, the
LED will flicker twice.
■
To remove a macro program
• When removing a macro program, perform the
above steps 1 and 3, but ignore the step 2.
■
To change a macro program
• When a new macro program is stored into a
MACRO button with performing the above steps
1 to 3, the previous macro program is cleared
from the memory of the MACRO button.
Operating a macro function
■
Notes:
• The codes programmed into a MACRO button will be
transmitted at an interval of 0.5 seconds. However,
some components may not be able to complete one
operation in 0.5 seconds and may miss the next code.
In this case, the macro function cannot control the
corresponding components correctly.
• Be sure to use the remote control within the remote
control operation range of the components.
• Depending on the operation status of the components,
etc., the macro function cannot control the
corresponding components correctly.
• Aim the remote control at the REMOTE SENSORs of
the components to be controlled and press the MACRO
button you want.
Example: When pressing “M1” button.
R-904(G)_ENG_091014:R-904(G) 2009-11-11 오후 12:05 페이지 17
