7
Operating Instructions
C
ONTROL
B
OARD
F
UNCTIONS
:
1. AUGER TRIM:
Used to change feed rates on LOW ONLY for poorer quality fuels. Push the Auger
Trim button until the number 1 and 5 lights appear on the Heat Level Indicator. This will increase the
feed rate to 2.5 seconds ON time Auger pulse. This is done only on LOW to allow the burning of poor
quality fuels. Push the button until the number 1 and 4 lights appear, this will reduce the Auger On
time to 1.5 second. This setting is for high-grade fuel only. Push the button until just the number 1
light is on, this is for a 2 second ON time (standard setting). Refer to Figure 3.
2. CONVECTION BLOWER CONTROL:
Used to turn the convection blower ON/OFF. Leave convection
blower ON for peak effiency.
�
�
�
�
�
�
�
�
3. AUGER PULSE LIGHT:
This light will flash in
conjunction with the auger.
4. MANUAL AUGER FEED:
If the unit runs out
of fuel, this button can be used to “prime the
auger system”. This button will turn off after 60
seconds and then must be released and pressed
again.
5. SYSTEM LIGHT:
Responsible for signaling
the state of the control board. When the light
is flashing during start-up, the stove is in an
automatic start mode. When the light is solid,
the Heat Level Setting can be altered.
6. ON/OFF BUTTON:
Used to turn the unit ON
and OFF.
7. HEAT OUTPUT INDICATOR:
Shows the
present heat output setting.
8. HEAT LEVEL ADJUSTMENT:
When pressed,
will change the heat setting of the unit from
low to high in five (5) steps.
Figure 2: Circuit Board Control Panel Decal
Auger Trim
Auger Trim
Auger Trim
1.5 Seconds
"ON"
2 Seconds
"ON"
Factory Setting
2.5 Seconds
"ON"
1
1
1
4
5
Figure 3: Auger trim and heat level indicator.
