5
Introduction
ASHES:
Disposed ashes should be placed in a metal container with a tight-fitting lid. The closed
container of ashes should be on a non-combustible floor on the ground, well away from all combustible
materials pending final disposal. The ashes should be retained in the closed container until all cinders
have thoroughly cooled before disposing of them.
ELECTRICAL: The use of a surge protected power bar is recommended.
The unit must be
grounded. The grounded electrical cord should be connected to a standard 220-240 volts, nominal
average 0.8 Amps (1.4 Amps peak), 50 hertz electrical outlet and also must be accessible. If this power
cord should become damaged, a replacement power cord must be purchased from the manufacturer or
a qualified ENVIRO dealer. Be careful that the electrical cord is not trapped under the appliance and that
it is clear of any hot surfaces or sharp edges. This unit’s maximum power requirement is 184 watts (322
watts peak).
GLASS:
Do not abuse the glass by striking or slamming the door. Do not attempt to operate the stove
with broken glass. The stove uses ceramic glass. Replacement glass must be purchased from an ENVIRO
dealer. Do not attempt to open the door and clean the glass while the unit is in operation or if glass is
hot. To clean the glass, use a soft cotton cloth and mild window cleaner, gas or wood stove glass cleaner,
or take a damp paper towel and dip into the fly ash. This is a very mild abrasive and will not damage the
glass.
FLAMMABLE LIQUIDS:
Never
use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter
fluid, or similar liquids to start or “freshen up” a fire in the heater. Keep all such liquids well away from
the heater while it is in use.
SMOKE DETECTOR:
Smoke detectors should be installed and maintained in the structure when
installing and operating a pellet burning appliance.
OPERATION:
The ash pan and door must be closed securely for proper and safe operation of the pellet
stove. Also ensure all gaskets on the door are checked and replaced when necessary.
KEEP ASH PAN FREE OF RAW FUEL.
DO NOT PLACE UNBURNED OR NEW PELLET FUEL IN ASH PAN. A fire in the ash pan may occur.
If you have any questions with regards to your stove or the above-mentioned information, please feel
free to contact your local dealer for further clarification and comments.
SINCE SHERWOOD INDUSTRIES LTD. HAS NO CONTROL OVER THE INSTALLATION OF
YOUR STOVE, SHERWOOD INDUSTRIES LTD. GRANTS NO WARRANTY IMPLIED OR STATED
FOR THE INSTALLATION OR MAINTENANCE OF YOUR STOVE. THEREFORE, SHERWOOD
INDUSTRIES LTD. ASSUMES NO RESPONSIBILITY FOR ANY CONSEQUENTIAL DAMAGE(S).
SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE
