Sherpa 901233, Safety Instructions And Operation Manual

Page: 3 / 20

3
Warning
Warning
Please carefully read all instructions provided before using this appliance . This heater
must be installed in accordance with the instructions and local regulations . The use of
this appliance in enclosed areas can be dangerous and is prohibited .
•
Perform the ‘leak test’ after each changing gas cylinder .
Never check for leaks with a naked flame
• Do not store other flammable vapors or liquids near this appliance.
If you smell gas, follow the steps below:
1 . Extinguish all naked flames; do not operate any electrical appliances
2 . Close the valve of the regulator to stop gas running to the unit and turn the heater to
the OFF position (full disk = • )
3 . Ensure the regulator is fixed to the bottle correctly.
4 . Check the hose from the gas bottle to the unit has no splits - this can be done with
soapy water to identify splits in the hose .
5 . If odour persist contact Heat Outdoors or a gas supplier .
Leakage Test
Gas connections on the appliance are leak tested prior to shipment . Possible mishandling
of the appliance during shipment can damage the integrity of some parts .
A complete gas leakage test must be performed again at the installation site . Please
follow the procedure below for leakage test .
1 . It is advised to make a soap / liquid detergent and water solution to identify any
holes/splits or loose fittings in the tube.
2 . Make sure the control tap is in the OFF position (full disk = • ) on the control panel .
3 . Apply the solution to the hose using a brush or rag .
4 . Turn ON the gas supply and check for bubbles from the hose . If the air bubbles
appear this indicates a leak in the hose .
5 . If a leak is present, turn OFF the gas supply immediately, tighten any leaking fitting
carefully, turn gas ON again and recheck .