71
70
Left handlebar control switch
Turn signal switch
E l e c t r i c s t a r t b u t t o n
F u e l t a n k c a p
1. Engine stop button
2. Horn button
3. Headlight (high beam)
4. Headlight (low beam)
5. Side lights
Press on button
1
to start
Opening: Turn the cap
1
counterclock-
wise
Closing: Turn the cap
1
clockwise
NOTE:
Do not fill to the brim as fuel
increases in volume as it gets hotter.
1. Right hand turn switch
2. Left hand turn switch
3. Push in to cancel
1
1
1
!
2.9 Button function
The function of the button varies depending on the function displayed, as shown
in the table below.
2.10 Initial installation of instrument
The default value of the wheel circumference is 2,091mm, and the unit of measu-
rement is k.p.h. for the speed and kilometres for distance; again by default, the sys-
tem is set to receive 1 impulse for each complete turn of the wheel. To modify any
of these parameters, it is necessary to proceed as per the instructions above.
During the initial installation of the instrument, the display will Visualize the version
and date of the software installed for about 2 seconds.
Immediately after the display’s Check, and the visualisation of the pre-set wheel cir-
cumference and number of impulses for each turn of the wheel, the system acti-
vates the standard operating mode.
Function
TIME
LAP
TOD
TD
COUNTDOWN
MODE
If T
≥
3” and Speed = 0, the time-setting function is activated
If T<3” or Speed>0, the functions may be scrolled through
If T
≥
3” LAP and TD are reset
If T<3” the functions may be scrolled through
If T
≥
3” and Speed>0, the circumference, unit of measurement and
number of impulses per turn of the wheel function is activated
If T<3” or Speed>0, the functions may be scrolled through
If T
≥
3” LAP and TD are reset
If T<3” the functions may be scrolled through
If T
≥
3” and Speed>0, the countdown setting function is activated
If T<3” or Speed>0, the functions may be scrolled through
1
2
3
5
4
