Value
of
the
butterfly
angle
position
should
be:
2.7
<3.1
<3.5
Check that the painting has not accidentally removed from the butterfly stop screw. Never touch
the butterfly stop screw.
The bike must be in perfect working condition (valves adjusted
Check that air by-pass air screw at the injector body is not unscrewed over two TURNS out
(factory
value:
1
round).
Make this adjustment with the engine running.
1- For this operation you must have a lambda probe and a gas analyzer.
- Run the engine until it reaches 80 ° C.
- Connect the CO detector
- Perform t
- In the Configuration menu
Do not exceed the range of -15 to +15. If you must get out of this range, there is a
problem (injector, TPS sensor, etc.).
2 – If you do not have a lambda probe and gas analyzer.
If your perfectly tuned bike has an unstable idle you can set it using the Trimmer function.
Do not exceed the range of -15 to +15. If you must get out of this range, there is a
problem (injector, TPS sensor, etc.).
Idle speed
Value
of
the
butterfly
angle
position
should
be:
2.7
<3.1
<3.5
Check that the painting has not accidentally removed from the butterfly stop screw. Never touch
The bike must be in perfect working condition (valves adjusted properly, fresh air filter, etc.).
pass air screw at the injector body is not unscrewed over two TURNS out
(factory
value:
1
round).
Make this adjustment with the engine running.
For this operation you must have a lambda probe and a gas analyzer.
Run the engine until it reaches 80 ° C.
Connect the CO detector
Perform the test in real conditions (saddle and air filter installed)
Configuration menu, set the CO at 5%
15 to +15. If you must get out of this range, there is a
ensor, etc.).
If you do not have a lambda probe and gas analyzer.
If your perfectly tuned bike has an unstable idle you can set it using the Trimmer function.
15 to +15. If you must get out of this range, there is a
lem (injector, TPS sensor, etc.).
Idle speed : 2.5i : 2200 +/-100tr/min
46/54
Value
of
the
butterfly
angle
position
should
be:
2.7
<3.1
<3.5
Check that the painting has not accidentally removed from the butterfly stop screw. Never touch
properly, fresh air filter, etc.).
pass air screw at the injector body is not unscrewed over two TURNS out
(factory
value:
1
round).
he test in real conditions (saddle and air filter installed)
15 to +15. If you must get out of this range, there is a
If your perfectly tuned bike has an unstable idle you can set it using the Trimmer function.
15 to +15. If you must get out of this range, there is a
Summary of Contents for 2012 SE 250i-R
