Shenzhen BACKUP BELT 002, User Manual

Page: 5 / 136

5
Support functionality
The support function of your Backup
Belt is completely analog and ready to
use. Put on the belt like this:
1. Make sure the belt is facing the
right way. The magnetic connectors
should face towards your body and
down.
2. The belt length can be adjusted by
moving the inner right & left belt
along the belt backplate, fastening
by means of the velcro. Max waist
diameter is 116cm.
3. To insert the main unit insert the
notch in the top of the main unit
into the matching tab on the belt
backplate. Then press main unit
through the opening allowing the
magnetic connectors on the main
unit & belt backplate to connect.
4. Hold the backplate with main unit
towards your lower back. If using
the optional gel pads see next
page for detailed instructions.
Grab the inner fastening belt and
wrap it around your body. Tighten
comfortably and fasten with the
Velcro. Right hand side goes over
the left hand side.
5. To tighten the supporting belt grab
both outer tensioning belts and pull
them until you feel you have desired
support. Fasten with the Velcro.
Right hand side goes over the left
hand side here too.
1 4
5
3
2
English