S k y t r a q V e n u s 6 B l u e t o o t h G P S K e y C h a i n 6 5 c h a n n e l s
Page 3
This wonderful Bluetooth GPS Key Chain is Made in Taiwan
E-3 Insert the software utility CD into your CD ROM driver
The installation program will start automatically. If the installation program did not start, please double click on “ gpsPhoto
Tagger_install.exe” on the CD to start it.
E-4 Turn on the device and connect the device to PC USB Port
GPS Photo Tagger software will automatically detect the port and transmitting braud rate. You may use the software utility to conduct the
following functions: upload the recorded data, make configuration settings to device, change recording interval, exporting and mapping your
recorded data. For more detail on how to use Photo Tagger Software, please refer to the user manual included within the software (Help->
User manual).
F. OTHERS
F-1 LED Indicators
LED Status
Flash
ON
OFF
1 Bluetooth (Blue)
Pairing Mode (Flashing every 8 seconds)
Connected
2 Power (Red)
Low Power (Flashing every 1 second)
Recharging
Sufficient Power
3 GPS (Green)
Satellite Fixed (Flashing every 3 seconds)
Searching signal
4 POI (Orange)
When POI making is confirmed (Flash 1 second)
F-2 Manufacturing Setting
Protocol: NMEA 0183 - GGA, GSA, GSV, RMC
Baud Rate: 9,600 bps; Datum: WGS-84
F-3 GPS Features
SkyTraq Venus 6
GPS Receiver with super high sensitivity at -160dBm
Frequency: L1, 1575.42 MHz; C/A Code: 1.023 MHz chip rate
Acquisition time: Hot start less then 1 sec. / Warm start 25 sec. / Cold start 29 sec. (averaged)
F-4 Bluetooth Features
Bluetooth Version: V2.0 / SPP profile
Class 2 with 10 meters in open space
F-5 Flash Memory Features
Built-in flash memory: 8M Bits for data logging with 8 bytes binary data per record
Storage: up to 100K data records
F-6 Overall Features
Built-in rechargeable 540mAh Li-Polymer battery (up to 8 hrs after fully charged)
Size: 47.0 (L) X 38.0 (W) X 13.0 (H) mm / Weight: 37g (Battery Included)
G. Trouble Shooting
Problems
Reasons
Methods
No position output but timer
is counting
Weak or no GPS signal can be received at the
place of the device
Find an open space for the device
Execute fail
Bluetooth function unstable
Re-Start PDA or PC or re-install software
Can not turn on the COM
port
Incompletely install the device or the COM port
of the device is being used
Install the device completely or stop other
device that is being used.
Can not find out the device
Poor connection
Re-Start PDA or PC and re-install software.
No Signal
No action for few minutes may cause the Pocket
PC enter power saving mode. It may close the
COM port at the same time.
Close the application and execute it again
to re-open the COM port.
No Signal
Weak or no GPS signal when using the device
indoor
Go outdoors to improve the poor GPS
signal.
