S k y t r a q V e n u s 6 B l u e t o o t h G P S K e y C h a i n 6 5 c h a n n e l s
Page 2
This wonderful Bluetooth GPS Key Chain is Made in Taiwan
B. Appearance
C. Charging your battery
D. Start to use (Bluetooth GPS Key Chain Function)
D-1 Full charge the battery when using at the first time
A fully charged battery can operation continuously up to 10 hours.
*
Battery use and standby times are estimations only and may vary according to signal strength, network conditions, features used and battery age (includs
the effect of user charging habits), temperatures to which battery is exposed, use in digital mode, and many other factors. Please note that the amount of
time a receiver issued for navigator will affect its standby time. Likewise, the amount of time that the GPS is turned on and in the standby mode will
affect its navigation time.
D-2 Activate the Bluetooth function in your PDA/Smart phone or PC
Before activating the Bluetooth function, please power on Bluetooth GPS key chain for pairing. Please check if your device is equipped with
Bluetooth function, if not, you may need to acquire an optional CF/SD Bluetooth card or Bluetooth dongle.
NOTE: The pairing procedure is required to execute in the first time only. And the pass code is “
0000
” if required.
D-3 Automatically create a shortcut in Bluetooth Manager window
After the pairing has complete, the system will then find a quick connect device “DATALOGG” in Bluetooth Manager. In further use, you
only need to click on the device na,e to connect to this Bluetooth GPS Key Chain.
D-4 Check the Serial Port in Bluetooth Setting
After complete pairing with the Receiver, please click “Serial Port” to confirm the assigned COM port. If you use PDA/PC to pair the GPS
Key Chain, please check “Outbound COM port”.
D-5 Set correct Serial Port in your map software
Activate your navigation software and make sure to select the correct “Serial Port”.
NOTE: In the map software such as TomTom, you might need to change preference and set “Other Bluetooth GPS” or “Other
Cable NMEA GPS” according to PDA/phone model. In some case please consult mapping software company to vary the setting if
you have issue on positioning.
E. Start to use (Data Logger & POI & Photo Tagger Functions)
E-1 Save and Record the position data
When you turn on the power switch, the device automatically starts to search the GPS connection. After the GPS position is fixed,
recording of trip information in location, time, altitude and speed would start automatically.
E-2 Record Point Of Interest
Press the POI button on Key chain, to mark a Point Of Interest identification balloon on the Track. The balloon is visible after uploading trip
information onto GPS Photo Tagger software.
For the first time using the Bluetooth GPS key chain, please charge battery until it is fully
charged. Take the USB cable and connect it to the mini USB connection port then
connect another side of USB to PC, Laptop or car cigarette adaptor. This will begin to
charge the battery. Charging time is 3 hours typically.
- When the red LED is blinking, battery power is low status. Please recharge.
- When the red Power LED is steady on, the battery is under charging mode.
- When the red LED is Off, the battery is fully charged.
Bluetooth Status LED
Power LED
GPS Status LED
Key chain
Power Switch
POI LED
POI Button
