05_10B163_0E
Page 7
3. InSTAll SIde RAIlS And SHelTeRlock
™
STABIlIZeR BlockS:
A.
Place assembled first end rib in the staked area.
Place the ShelterLock
™
on the upright as shown in
Detail D. From the outside of the rib insert the bolt
through the upright and then through the ShelterLock
™
.
B.
Place the plain end of the side rail over the bolt and
nest it into the ShelterLock
™
. Install the nut onto the
bolt and tighten. Repeat these steps for the opposite
side and all of the remaining ribs. The side rails for the
last rib will have two plain ends.
NOTE:
Sliding Cover Rail (11105) should be attached
to frame after Step 9, once cover is installed. See Step
10.
4. InSTAll WInd BRAceS:
Attach wind brace between the end rib and the first middle rib as shown in Detail E.
Bolts attached at the cross rails should be inserted facing inside the shelter.
DETAIL D
DETAIL E
FIRST
MIDDLE
RIB
wIND BRACE
END RIB
11102
11104
800442 on
20' high only
11104
11104
800372
00690
800454
wIND BRACE
800440 for 16'
and 20' high
11131
11134
