Page 3
Basic Frame Assembly
STEP 2: ASSEMBLE END RIBS
Fig. 2
STEP 3: ASSEMBLE MIDDLE RIBS
Fig. 3
STEP 4: ASSEMBLE WIND BRACES
Fig. 4
Fig.3
Fig.2
Fig. 4
#648
#690
#11095
#11093
11136
Use #11131
5/16" x 2 3/4" Bolts
End Rib
Use #11131
5/16" x 2 3/4" Bolts
Middle Rib
STEP
1: PLOTTING THE FRAME
Fig. 1
22'
22'
Length
of Building
Before building your shelter, you should choose a flat area on your property and plot
your shelter.
1.
Stake out the area for the shelter in the desired spot. The width of the area
should be at least equal to the width of the shelter and the length should be
equal to the length (“L”) of the shelter Fig. 1.
2.
To be sure the staked area is square tie a rope diagonally from corner to corner.
3.
Measure from where the two ropes intersect each other to all 4 corners. This
measurement should be the same. If they are not equal the stakes need to be
adjusted until the width, length and inside measurements are correct.
11013
11013
11068
11068
Assemble end ribs as shown in Fig. 2. Securely
fasten all of the joints with the hardware indicated.
Assemble all of the middle ribs as shown in Fig. 3. Securely fasten
all of the joints with the hardware indicated.
Fig.1
Assemble all of the wind braces as shown in
Fig. 4. Securely fasten the joints with the
hardware indicated.
11016
11016
11135
11013
11013
11068
11068
11019
11019
22'x20'x10' is the base frame dimension. Your model may have more middle ribs than shown in the illustration on pg.2. You will
receive one extra rib for every extra 4 ft. of building length that you purchase. The basic frame assembly will remain the same. The
cover will be the correct size for the length of the building.
NOTE: FRAME EXTENSION KIT
