05_107153_0D
Page 7
A.
Hold end panel at the top center with white inner surface facing inside of the shelter. (If you purchased the
white cover, the inner face has the visible weld seams.) Wrap the edges of the fabric panel around the end rib.
B. Disconnect top cross rail (the horizontal pipes that run from front to back along the top) from the end rib. Pull
the webbing (the black strap) below the cross rail. Reattach the top cross rail to the end rib. Repeat Step B
for side cross rails (the horizontal pipes that run from front to back along the sides of the unit, near the bend
in the frame where the legs meet the roof).
C.
Remove the nut from the side rail and carefully pull the side rail away from the
ShelterLock
™
(pull away
only enough to pass the webbing through the connection).
If this connection has the wind brace on it
remove the wind brace end before pulling the side rail.
Replace the cross rail and wind brace. Replace the
nut and tighten. Repeat this on the other side.
D.
At the bottom, where the webbing exits the pocket on each side of end panel, pull webbing to remove the
slack.
Be careful not to pull the webbing through the other side of the webbing pocket.
E.
Insert the “S”- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet
and pull tight. Wind the ratchet so that the webbing overlaps itself.
Position the end panel so that it is centered on the building before fully tightening the end panel.
F.
Tighten ratchets, alternating from one side to the other, until the end panel is centered and tight.
11. end And dooR PAnel InSTAllATIon
SIde
cRoSS RAIlS
WeBBInG
zIPPeRS
ToP cRoSS
RAIl
WRAP end
PAnel
edGeS
To InSIde
oF FRAme
InSIde VIeW oF end RIB
SIde VIeW oF end RIB
WInd
BRAce
ImPoRTAnT!
DO NOT INSERT ANY PIPES
INTO THESE POCKETS.
WRAP end PAnel edGeS oVeR And ARoUnd
PIPe ToWARdS InSIde oF FRAme.
noTe:
Keep Zippers closed when tightening end panels.
Thread Webbing Into Ratchet
Webbing and Ratchets Securing End Panel
Fig.11
