OPERATION
Before First Use
Before using for the first time, fill the kettle to the maximum level (Do not overfill) with cold tap
water; bring to the boil and then discard (this may need repeating more than once). Wipe the
outside of the kettle with a damp cloth. Do not immerse the kettle in any liquid. Do not use
detergent to clean the inside of the kettle
Place the kettle base on a flat level surface. Do not operate on an inclined surface.
Connect to a suitable power supply of 220-240~V AC 50/60Hz.
The kettle must be filled with water BEFORE attaching to the base. To fill, open the lid by
pushing the lid opening button in and fill with clean cold water through the top. The water level
must be between the MIN & MAX marks as shown on the external water level gauge. Close the
lid.
CAUTION
If the kettle is overfilled, boiling water may be ejected.
Place the kettle carefully onto the power base ensuring it is correctly aligned. Switch the power
on by pressing the ON / OFF switch. The control lamp on the water indicator shows that the
water is being boiled.
Do not move the kettle while it is switched on. At the completion of boiling the ON / OFF switch
will automatically turn off. To turn the kettle off before it has boiled, press the ON / OFF switch.
Do not move the kettle on or off the base while it is switched on.
WARNING
Do not open the lid while water is boiling or while pouring. DO NOT OVERFILL AS
BOILING WATER MAY BE EJECTED.
Remove kettle carefully from base by lifting vertically upwards. Take care when removing kettle
from base. Ensure that the kettle is switched off before removing from base. Carefully pour
water from the kettle through the spout. CAUTION Hot steam may be ejected when pouring or
opening the lid.
IMPORTANT PRECAUTIONS TO PREVENT DAMAGE TO YOUR KETTLE
•
NEVER REMOVE THE KETTLE FROM IT'S BASE WHILE IT IS SWITCHED ON.
•
NEVER PLACE THE KETTLE ON IT'S BASE WHILE IT IS SWITCHED ON.
•
NEVER ROTATE THE KETTLE ON IT'S BASE WHILE IT IS SWITCHED ON.
•
NEVER OPERATE THE KETTLE WITH THE LID OPEN
•
DO NOT OPERATE THE KETTLE UNLESS THE ELEMENT IS FULLY IMMERSED.
•
THIS KETTLE MUST ONLY BE USED WITH THE STAND PROVIDED.
•
THE BASE AND EXTERIOR OF THIS KETTLE MUST NOT BECOME WET.
•
DO NOT USE ALKALINE CLEANING AGENTS, HARSH SOLVENTS OR ABRASIVE LEANSERS
WHEN CLEANING.
FAILURE TO OBSERVE THE ABOVE PRECAUTIONS MAY VOID ANY WARRANTY
