Stereo Setup
2. Plug the
SYSTEM CONTROL
cord (D) from the main unit into the
SYSTEM
CONTROL
cord (E) from the satellite unit.
3. Plug one end of the audio cable (C) into the
AUDIO
jack on the back cabinet
of the main unit and the other end into the
AUDIO
jack on the satellite unit.
4. Plug the FM wire antenna (A) into the
FM ANT
jack on the back cabinet of the
main unit. For best results, fully extend the wire antenna and hang the circular
end from a nail in the wall.
5. Plug the single cord (B) from the subwoofer unit into the
SUBWOOFER OUT
jack on the back cabinet of the satellite unit.
6. To select either 12- or 24-hour clock mode, slide the
12H/24H TIME
switch
on the back cabinet of the main unit to the desired mode.
Note:
To reset the unit to the alternate clock mode at a future time, you must first
unplug the unit from the wall outlet, slide the
12H/24H TIME
switch on the back
cabinet to the alternate setting and then plug the unit back into the wall outlet.
7. For use in the USA or Canada, slide the
AM FREQ SETUP
switch to 10 kHz.
For use in other areas, slide the
AM FREQ SETUP
switch to 9 kHz.
8. Plug the small end of the DC power cord into the
DC IN
jack on the back
cabinet of the satellite unit and the large end into a wall outlet.
Important:
Remove the protective sheet of paper from the CD tray in the main
unit. To open the CD lid, press the
OPEN
button
Battery Installation
Remove the battery compartment cover from the back of the remote and insert 2
AAA batteries, observing /- polarities as indicated inside the compartment.
Replace cover.
Power and Function Selection
1. To turn the unit on, press the
POWER
button on the main unit or remote.
The unit turns on in the function last used.
2. To change the function, press the
POWER/FUNCTION
button on the main
unit or the
FUNCTION
button on the remote.
3. To turn the unit off, press and hold the
POWER
button on the main unit or
press the
POWER
button on the remote. The clock appears on the LCD.
Quick Start
Summary of Contents for GT800
Page 2: ......
