Sharper Image 204939, Owner'S Manual

Page: 5 / 8

5. Timer presets (2,4,6,8 hours): Press this will turn the unit ON and go into
standby Mode after# hours. Timer settings will
be saved until "timer reset" button is pushed
or if the projector unit is unplugged. A
triple-flash indication from the projector
will confirm your timer setting.
6. Timer reset: Press this to reset and turn off the timer.
SYNCING THE REMOTE
• With your remote ready (battery installed) and making sure you are within
range of the laser (approx. 30 ft). Plug in the laser projector power supply
adapter to the power source.
• Within 1 minute after plugging in the laser, press the ON/OFF button on
your remote for 5 seconds to sync it to the laser projector.
• Do not press the ON/Off button at the same time you plug in the adapter
to the power supply.
• You can synch up to 4 laser projectors with one remote control.
• Occasionally, re-syncing the remote with the laser projector may be
necessary.
• To re-sync, unplug the laser projector from the power source, then repeat
the first two steps above.
• To sync more than one laser projector, unplug them all, wait 1 minute,
then plug them back in at the same time, then press the ON/OFF button
within 5 seconds.
• Remove the battery from the remote if you are planning on storing the
laser projector for a long period of time.