Sharp YC-MG02U-S, Operating Instructions Manual

Page: 28 / 32

EN-26
TROUBLESHOOTING
If you think the oven is not working properly,
there are some simple checks you can carry out
yourself before calling the SHARP customer
helpline. This will help prevent unneccessary
service calls if the fault is something simple.
Follow this simple check list below:
Place half a cup of water on the turntable and
close the door. Programme the oven to cook for
1 minute using 100% microwave power.
1. Does the oven lamp come on when it is
cooking?
2. Does the turntable rotate?
3. Does the cooling fan work? (Check by placing
your hand above the air vent openings.)
4. After 1 minute, does the audiable signal sound?
5. Is the water in the cup hot?
Take the cup of water out of the oven and close
the door.
that the oven is plugged in properly and that the
fuse has not blown. If there is no fault with either,
check against the Troubleshooting Chart on the
following page.
WARNING:
Never adjust, repair or modify the oven
yourself.
This is important as it may involve the
removal of covers that provide protection
against microwave energy.
- The door seal stops microwave leakage during
oven operation, but does not form an airtight
seal. It is normal to see drops of water, light or
feel warm air around the oven door. Food with
a high moisture content will release steam and
cause condensation inside the door which may
drip from the oven.
use the oven if it is not operating properly.
- Outer Cabinet & Lamp Access: Never remove
the outer cabinet. This is very dangerous due
to high voltage parts inside which must never
be touched, as this could be fatal.
cover. If the lamp fails, do not attempt to
replace the lamp yourself, call the Sharp Helpline
for support
For support, please contact the
Sharp Helpline.
WARNING: Do not remove the mains plug.
Contact the Helpline if you require advice.
EN-26