E-12
How to set up the projector and screen
Cautions: When setting up the projector
•
For minimal servicing and to maintain high image quality, SHARP recommends that this projector be installed in
an area free from humidity, dust and cigarette smoke. When the projector is subjected to these environments,
the lens and filter must be cleaned more often. Periodically the filter should be replaced and the projector should
be cleaned internally. As long as the projector is properly maintained in this manner, use in these environments
will not reduce the overall operation life. Please note that all internal cleaning must be performed by an Autho-
rized Sharp Industrial LCD Products Dealer or Service Center.
•
Do not expose to extreme heat or cold.
Operating temperature: 41°F to 104°F (+5°C to +40°C)
Storage temperature:
1
4°F to 140°F (
1
20°C to +60°C)
•
Do not tilt the projector more than 5°.
SIDE VIEW
TOP VIEW
The projector lens should be centered
in the middle of the screen.
Lens center
■
Using the horizontal reverse function makes the following setups possible.
Example of a reversed image setup
•
By placing a mirror (normal flat type) in front of the lens and using the horizontal reverse function, the image
reflected from the mirror can be projected onto the screen.
•
Rear projection with a rear projection screen is also possible when using the horizontal reverse function.
Rear Projection
If the projector and screen are not
centered properly, the picture will be
distorted, making viewing difficult.
The projector lens should be centered
in the middle of the screen.
AUDIENCE SIDE
▼
▼
Mirror
Example of a standard setup
■
Position the screen so that it is not in direct sunlight or room light. Light falling directly onto the screen washes out
colors, making viewing difficult. Close the curtains and dim the lights when using the screen in a bright or sunny
room.
■
The best picture will be obtained when the projector is at a 90 degree angle to the screen. Position the projector
and screen as shown.
Lens center
If the projector and screen are not
centered properly, the picture will be
distorted, making viewing difficult.
