2
3
2 - 5
CAMERA
White knob
4
5
The fluorescent lamp backlight used in this
CAM will eventually need replacing.
If you continue to use the
when the fluo-
rescent lamp has almost reached the end of its ser-
vice life, the “REPLACE THE
indicator will
appear in the centre of the monitor screen, and the
monitor will turn off approximately one minute later.
When this occurs, purchase a replacement lamp
from your dealer or a SHARP Full
Line Parts Distributor, and replace the old lamp.
REPLACING THE FLUORES-
CENT LAMP BACKLIGHT
1
Set the Operate switch to OFF to turn off the
and wait about 15 minutes for the
lamp unit to cool down.
Rotate the lens part of the
halfway
forward in the direction of the arrow
and
then remove the fluorescent lamp compartment
cover
using a pointed object such as the
point of a pen, push the cover release
to-
ward the monitor side, and then pull outward.
Carefully hold the end (white knob) of the fluores-
cent lamp unit with tweezers, and pull the lamp
unit out.
Insert the replacement fluorescent lamp unit into
the compartment. See note below.
Replace the fluorescent lamp compartment
cover.
Notes:
l
Be sure to insert the replacement fluorescent lamp
straight in, in the direction of the arrow, into the compart-
ment. Do not press diagonally as it may cause contact
failure.
l
The fluorescent light may flicker when first turned on.
Should this occur, turn off the
and then turn it
on
again.
Cautions:
l
The fluorescent lamp is hot during and immediately after
use of the
Wait at least 15 minutes after
turning the power off before attempting to change the
lamp, to allow time for it to cool down.
l
Attempting to change the fluorescent lamp while it is still
hot may result in burns or other injuries.
41
