GB-9
INSTALLING YOUR VCR
AUTO INSTALLATION
13.
Press [
/
] to select SAT NO. Turn to the table at the end of this manual. Look for
the make of your satellite receiver and use the
NUMBER BUTTONS
to enter the first
code number listed. For example number 8 should be entered 0 0 8. Your satellite should
now change to preset channel 12.
14.
If your satellite receiver has changed to preset channel 12, press
SET
to confirm the VCR
will automatically install both satellite and terrestrial channels. (This may take a few
minutes).
15.
The VCR will attempt to copy the TV preset list (NexTView compatible TV’s only). During
the copying process the display will show the TV presets that are being copied. If the VCR
is unable to copy the TV preset list the terrestrial and satellite channels will be
automatically installed. (Auto install may take a few minutes.)
On completion the MOVE menu will appear showing the preset channel order. By
pressing the
Mode OSD
button, the VCR will change to a blue background. This may
help you see which channels your VCR has tuned in. Press
MENU
to exit. The correct
Time and Date should be displayed on your TV screen for approximately
2
seconds. If the
clock is not automatically set, the clock screen will appear, refer to
MANUALLY
SETTING THE CLOCK
.
If you wish to customise the channel order refer to
MANUALLY SORTING
CHANNELS
.
NOTES:
All the programmes should now be correctly tuned in and the clock
set.
If you replace your satellite receiver, you will need to follow the complete auto-
installation procedure to tune your VCR to the satellite receiver. This is because your
new satellite receiver will not over-write the previous satellite channels in your VCR.
• If your satellite receiver has not changed to preset channel 12 enter the next code
number on the list. Continue until the receiver shows preset channel 12, then continue
from point 14.
• If your satellite receiver is not listed at the end of this manual or after entering all the
numbers listed for your receiver, the satellite receiver preset channel has still not changed
to 12, enter
0 0 1
, and look to see if the satellite receiver has changed to preset channel
12. If it has, continue from point 14. If not, press
to select
0 0 2
and re-check. Continue
until your receiver changes to preset 12, then continue from point 14.
• If there is still no response from your satellite receiver, try adjusting its position to improve
the Infra Red VCR to satellite receiver reception.
• Auto-installation will stop when the satellite receiver reaches preset channel 99, or when
all the 99 VCR preset channels have been used.
•
The VCR will place all found terrestrial channels starting at preset 1, then all satellite
channels from the first available preset channel after the terrestrial channels.
If you connect a satellite receiver to the VCR for the first time, after auto-installation, see
SATELLITE RECEIVER / CABLE BOX INSTALLATION
.
Module 03E.fm Page 9 Thursday, September 14, 2000 12:47 PM