25
Dimensions: 257
⳯
182 mm
V C - A 5 6 5 U / H 9 6 5 U ( 2 3 - 2 5 )
Playback
佡
Poor Tracking
Normal Picture
Video Search
Use the following procedure to quickly find the section you want, while viewing the picture.
!
During playback, press
FF
for forward video search or
REW
for reverse video search.
There are 2 search speeds in each direction. The VCR switches between them each time the button is
pressed.
@
Press
PLAY
to resume normal playback.
Slow Motion Playback (only with the remote control)
!
Press
SLOW
during playback.
@
Press
SLOW
j
/
k
(to the right of SLOW) to vary the slow motion playback speed between
1
⁄
5
and
1
⁄
30
of the
normal playback speed.
If noise bars appear on the screen, use
CH
∂
/
ƒ
.
If the picture experiences vertical jitter during the slow mode, set your VCR to the still mode and press
CH
∂
/
ƒ
to stabilize the picture. Then press
SLOW
again.
#
Press
PLAY
to resume normal playback.
Still Picture and Frame Advance
!
Press
PAUSE/STILL
during playback. This will freeze the picture on your TV.
@
If the picture vibrates vertically during still mode, use
CH
∂
/
ƒ
to adjust for minimum distortion. If noise bars
appear on the screen during still mode, set your VCR to the slow mode and press
CH
∂
/
ƒ
to make the
noise disappear. Then press
PAUSE/ STILL
again.
#
Press
PAUSE/STILL
during still mode for frame advance.
$
Press
PLAY
again to resume normal playback.
•
Sound is muted during still picture, video search, frame advance and variable slow motion.
•
The picture quality in still picture, video search, frame advance and variable slow motion is best with tapes recorded in SP
or EP mode.
Automatic Tracking Control System
This function automatically adjusts the tracking to match the
recorded tape. Auto tracking engages in the following cases:
• When you insert the cassette and begin playback.
• When you press
CH
∂
/
ƒ
at the same time.
• When the VCR has been playing back an unrecorded
section of tape and then reaches a recorded tape segment.
When auto tracking engages, “PLAY” on the TV screen flashes for a few seconds.
Manual Tracking Control
When a poorly recorded tape is playback or the VCR is near an electrical or magnetic field, auto tracking may
not operate normally. In this event, manually adjust the tracking with
CH
∂
/
ƒ
to make any noise disappear.
Blue Screen Noise Elimination
Set the BLUE SCREEN mode to ON on the SET UP–selection screen. (See
Mode Selection
.) This function
eliminates monitor noise and mutes sound during playback of unrecorded portions of a tape and when
receiving a non-broadcasting channel. Blue Screen will also appear if the VCR is set to the Auxiliary mode but
no video signal is fed to the VCR. (The BLUE SCREEN mode is set to ON at the factory.)
• Blue Screen does not function during still picture, variable slow motion and video search.
• Blue Screen may not function properly if the broadcast signal is too strong or too weak.
• Blue Screen does not function during playback of a tape with noise recorded.
• If the antenna signal is weak while recording a TV programme or if the input signal is weak while tape dubbing, the monitor
screen may turn blue since the unit may not recognize whether or not a proper signal is being received. In this event, set the
BLUE SCREEN mode to OFF.
Basic
Operations
Summary of Contents for VC-A565U
Page 39: ...39 Memo ...