Sharp SJ-FJ676V, Operation Manual

Page: 3 / 16

3
WARNING
Do not install the refrigerator in a damp or wet location ■
as this may cause damage to the insulation and a
leakage. Condensation may also build on the outer
cabinet and cause rust.
1
Keep adequate ventilation space around the refrigerator.
The fi gure shows the minimum •
required space for installing
the refrigerator.
The amount of space around
the refrigerator affects
the amount of power
consumption.
Insuf fi cient spacing will •
decrease cooling ef fi ciency
and increase energy
consumption.
This may reduce the life of the unit and void warranty.
If using the refrigerator in the smaller space dimension •
than the below fi gure, it may cause the temperature
rise in the unit, loud noise and failure.
The space between the rear of the refrigerator and the •
wall should be 60mm or more and less than 75mm.
If the space is wider than 75mm, you may get injured
by touching compressor and its peripheral parts which
are extremely hot during the operation.
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned fi rmly and fl at on the fl oor.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
INSTALLATION
3
When right and left doors are not properly aligned, adjust
using the adjustable feet.
NOTE
Position your refrigerator so that the plug is accessible. •
Keep your refrigerator out of direct sunlight. •
Do not place next to heat generating appliance. •
Do not place directly on the ground. Provide suitable stand. •
If the mains power is switched on when the door is open, the •
door alarm will sound. Close the door to stop the alarm.
Adjustable foot
When the left door is
raised.
When the right door is
raised.
Lower the foot
at right side.
Lower the foot
at left side.
(Until the adjustable foot on the
other side is slightly off-ground.)
4
Remove the 4 screws of the cabinet lower part, and
then set the foot cover (supplied inside the refrigerator
compartment) with removed 4 screws.
Screw
(4 screws)
Screw
Foot cover
5
Connect the power plug to a 230/240 volt. 10 amp.
power point.
1180 mm
1500 mm
Overall space
required in use
Free standing type
90mm
or more
60mm
or more
60mm
or more
(B493).indb 3 (B493).indb 3 2013/09/17 9:57:33 2013/09/17 9:57:33