background image

9

WARNING

Unplug the refrigerator first to prevent electric 

shock.

Do not splash water directly on the outer cabinet 

or the interior. This may lead to rusting and 

deterioration of the electrical insulation.

IMPORTANT

To prevent cracking on inside surfaces and plastic 

components, follow these tips: 

• 

Wipe any food oils adhered to plastic components.

• 

Some household chemicals may cause damage, so use 

only diluted washing-up liquid (soapy water).

• 

If undiluted detergent is used or soapy water is not wiped 

off thoroughly, cracking of plastic parts can result. 

• 

Wipe any spills from the refrigerator immediately as acid 

or alkaline in the food can cause cracking and staining of 

plastic parts.

Remove the shelves and pockets from the cabinet and 

door. Wash them in warm soapy dishwashing water; 

rinse in clean water and dry. 

Clean the inside with a cloth soaked in warm soapy 

dishwashing water. Then, use cold water to wipe off 

soapy water.

Wipe the exterior with a soft cloth each time it is soiled. 

Clean the magnetic door seal with a toothbrush and 

warm soapy dishwashing water. 

Wipe the control panel with a dry cloth. 

NOTE 

• 

Do not use hot water, household cleaning powders, creams 

or spray-on cleaning products, or any other cleaning 

products such as mineral turpentine, methylated spirits, 

thinners, petrol etc. These may damage your refrigerator 

and may void any warranty.

• 

If the power supply is disconnected, please wait for at least 

5 minutes before re-connecting power.

• 

The glass shelves weigh approximately 3 kg each. Hold 

firmly when removing from the cabinet or carrying. 

• 

Wipe any spills from the control panel immediately as liquid 

ingress can damage the electronics.

• 

Do not drop objects inside the refrigerator or strike the inner 

wall. This may cause the inner surface to crack.

When the compartment light is blown

Contact the service agent approved by SHARP to request 

a replacement compartment light. The compartment light 

is not to be removed other than by qualified service 

personnel. 

Switching off your refrigerator 

If the refrigerator needs to be switched off for an extended 

period, the following steps should be taken to reduce the 

symptom of mould:

1. 

Remove all food.

2. 

Remove the power plug from the power point.

3. 

Clean and dry the interior thoroughly.

4. 

Ensure that all the doors are wedged open slightly for 

air circulation.

Before you call for service, check the following points.

If you still require service

 contact your SHARP Approved Service Centre.

SHARP Approved Service Centre locations can be found in the Support area of our website:

Australia : http://www.sharp.net.au
New Zealand : http://www.sharp.net.nz

CARE AND CLEANING

Problem

Solution

The outside of the cabinet is hot 

when touched.

This is normal. The hot pipe is in the cabinet in order to prevent condensation 

generation.

When there is refrigerator 

noise.

It is normal for the refrigerator to produce the following sounds:

• 

Loud noise produced by the compressor when operation starts 

--- Sound becomes quieter after a while.

• 

Loud noise produced once a day by the compressor 

--- Operating sound produced immediately after automatic defrost operation.

• 

Sound of flowing fluid (gurgling sound, fizzing sound) 

--- Sound of refrigerant flowing in pipes (sound may become louder from time to time).

• 

Cracking or crunching sound, squeaking sound 

--- Sound produced by expansion and contraction of inner walls and internal parts 

during cooling.

Frosting or condensation 

generation occurs inside or 

outside the refrigerator.

This may occur in one of the following cases. Use a wet cloth for wiping frost and a 

dry cloth for wiping condensation.

• 

When the ambient humidity is high.

• 

When the door is frequently opened and closed.

• 

When food containing plenty of moisture is stored. (Wrapping is required.)

The foods in the refrigerator 

compartment freeze.

• 

Is the refrigerator operated for a long time with refrigerator temp. control set at 0°C?

• 

Is the refrigerator operated for a long time with freezer temp. control set at -21°C?

• 

Low ambient temperature may cause food to freeze even if refrigerator temp. 

control is set to 6°C.

Noticeable odours.

• 

Wrapping is required for food with strong odours.

• 

Deodorising unit cannot remove all of the odours.

BEFORE YOU CALL FOR SERVICE

(B007) Eng.fm  Page 9  Thursday, May 28, 2009  5:03 PM

Summary of Contents for SJ-F602SP












Reviews: