8 – 4
[2] F-LOUVER ASS'Y (SJ-A31S/A34S)
1. Fan motor ass'y
1. Stick U-sealer handle to Fan motor holder a (Fig. A-2).
2. Insert the terminal of Lead EV-cover to Fan motor (Fig. A-3).
3. Insert shaft of Fan motor to the hole of motor cushion, set at Fan motor holder a.
Next, insert the boss of rear to the hole of Motor cushion, set at fan motor b.
Then fix with Tapping screw (2 pieces).
4. Set Fan clamp to propeller fan 100 mm. and then insert it to the shaft of Fan motor( Fig. A-4).
Fan clamp
Propeller fan 100
Fan motor holder a
U-sealer handle
Motor cushion
Fan motor
Motor cushion
U-sealer handle
Fan motor holder b
Tapping screw
Tapping screw
Slit area
BROWN
RED
Lead EV-cover
Figure A-1
Fan clamp
slit
slit
SEC. C-C
Fan motor holder a
U-sealer handle
Fan motor holder a
U-sealer handle
Fan motor
(1) Slit of each Fan Clamp and propeller fan 100 should not be at same
position.
(2) Fan clamp should be inserted virtically to the end of boss.
(3) Propeller fan should not be taken out from shaft when pulled by 2 kgf.
(1) Assemble so that terminal of Fan motor does not deform.
(2) Take care not to stress to terminals of Fan motor after wiring.
(3) Check locking by pulling them with more than 10N(1 kgf).
Note
Note
Figure A-4
Figure A-2
Figure A-3
Propeller fan 100
Detail of D
Fan motor holder a
Fan motor holder b
Motor cushion
Motor cushion
Fan clamp
Propeller fan 100
Fan motor
Fan clamp
NO GOOD
GOOD
WIRE COLOR IS GRAY/ORANGE
(127V : with yellow tape)
Lead EV-cover
!"#$% &'$( &#$) &'$* &#$+ &'$, &#-( &#-)
