8 – 1
SJD26LVSL
CHAPTER 8.
ASSEMBLING PROCEDURES OF MAIN PARTS AND CAUTIONS
CAUTION: DISCONNECT THE UNIT FROM THE POWER SUPPLY BEFORE ANY REPAIRING.
[1] F-LOUVER ASS'Y (SJ-A20S/B21S/A24S/B25S/A28S/B27S)
1. Fan motor ass'y
1. Stick U-sealer handle to Fan motor holder b (Fig. A-2).
2. Insert the terminal of Lead EV-cover to Fan motor (Fig. A-3).
3. Insert shaft of Fan motor to the hole of motor cushion, set at Fan motor holder b.
Then insert the boss of rear to the hole of Motor cushion, fix with Tapping screw(1 piece).
4. Set Fan clamp to propeller fan 90 mm. and then insert it to the shaft of Fan motor( Fig. A-4).
Fan motor holder b
U-sealer handle
U-sealer handle
Motor cushion
Lead EV-cover
Fan motor
Motor cushion
Fan motor holder a
Propeller fan 90
Fan clamp
Slit area
Figure A-1
Fan motor holder b
U-sealer handle
U-sealer handle
Fan motor holder b
Lead EV-cover
Fan motor
Fan clamp
Propeller fan 90
Detail of D
Propeller fan 90
Fan clamp
Fan motor
Motor cushion
Motor cushion
Fan motor holder b
Fan motor holder a
Note
(1) Assemble so that terminal of Fan motor does not deform.
(2) Take care not to stress to terminals of Fan motor after wiring.
(3) Check locking by pulling them with more than 10N(1 kgf).
Note
(1) Slit of each Fan Clamp and propeller fan 100 should not be at same
position.
(2) Fan clamp should be inserted virtically to the end of boss.
(3) Propeller fan should not be taken out from shaft when pulled by 2 kgf.
(127V : with yellow tape)
WIRE COLOR IS GRAY/ORANGE
GOOD
NO GOOD
slit
Fan clamp
slit
SEC. A-A
Figure A-4
Figure A-2
Figure A-3
!"#$% &'$( &#$) &'$* &#$+ &'$, &#-( &#-)
